![]() This will cause the channel to be updated the same way as in openHAB versions prior to 3.3. The moving average calculation can be disabled by setting either currentPowerSlidingSeconds or currentPowerDeltaTrigger to 0. Sliding window in seconds for which moving average power is calculated (0 = disabled)ĭelta triggering immediate channel update (in Watt) The UDN identifies the WeMo Insight Switch So when changes are happening fast, the channel will also be updated fast. The rounded value received is more than 1 W from the previous value. ![]() ![]() This introduces a delay for very small changes in consumption, but on the other hand it prevents excessive logging and persistence caused by temporary small changes and rounding. The rounded value received is equal to the rounded average for the past minute, i.e.This means that the channel is only updated when one of the following conditions are met: This is combined with a delta trigger value, which is defaulted to 1 W. This window is defined with a one minute default period. To mitigate this issue, a sliding window with a moving average calculation has been introduced. When persisting items linked to this channel, this can result in a significant amount of data being stored. These raw values are reported with high frequency, often multiple updates can occur within a single second.įor example, the sequence of 40.440 W, 40.500 W and 40.485 W would result in the channel being updated with values rounded to nearest integer, respectively 40 W, 41 W and 40 W. The internal theoretical accuracy is 5 mW, i.e. This channel reports the current power consumption in Watt. The WeMo Insight Switch has some additional parameters for controlling the behavior for channel currentPower. The device ID identifies one certain WeMo light Most devices share the udn configuration parameter: Configuration Parameterįor LED Lights paired to a WeMo Link bridge, please use the following configuration parameter: Configuration Parameter It can most easily be obtained by performing an auto-discovery before configuring the thing manually. # Thing Configurationįor manual Thing configuration, one needs to know the UDN of a certain WeMo device. The binding does not need any configuration. The WeMo devices are discovered through UPnP discovery service in the network.ĭevices will show up in the inbox and can be easily added as Things. Coffee Smart Coffemaker as well as the Holmes Smart Air Purifier, Holmes Smart Humidifier and Holmes Smart Heater. The Binding also supports the Crock-Pot Smart Slow Cooker, Mr. The WeMo Binding supports the Socket, Outdoor Plug, Insight, Lightswitch, Motion, Dimmer, Coffemaker and Maker devices, as well as the WeMo-Link bridge with WeMo LED bulbs. The integration happens either through the WeMo-Link bridge, which acts as an IP gateway to the Zigbee devices or through WiFi connection to standalone devices. This binding integrates the Belkin WeMo Family (opens new window).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |